Product Manual

A-2 SEER
®
Light 2040604-012D
Troubleshooting
Troubleshooting Chart
Use the chart below to troubleshoot problems.
Trouble Cause Recommendation
Alarm sound continues when batteries are
inserted.
(Recorder)
Battery power is low.
Wrong type of batteries, or batteries other
than alkaline are inserted.
Replace with new alkaline batteries.
No beeping sound when batteries are
inserted.
(Recorder)
Battery power is low. Replace with new alkaline batteries.
Batteries are reinserted quickly right after
completing the data transfer.
This may occur because the condenser in
the recorder has power reserve function.
Reposition batteries 30 seconds after
replacement, and resume the function.
The damage may be caused by physical
shock.
Check with service, or open a service call.
No beep sound for start-up when is
pressed.
(Recorder)
The button was pressed too rapidly. Press gently and slowly.
The recorder is already in the recording
process.
Press again 30 seconds after
batteries are reset.
It has been more than 1 hour after batteries
are inserted.
The recorder automatically cancels start-
ready mode in order to reduce battery
power loss. This function makes the
button inactive.
The recorder does not start up when the
controller sends a start up command
through infrared, and The recording has
already started. is displayed.
(Recorder and controller)
The recorder is already in the recording
process.
Press F6 again 30 seconds after batteries
are replaced.