Specification

18
Remote Control
REMOTE FUNCTIONS
Low speed
Medium speed
Power ON/OFF
High speed
Delays the light turning off for approximately 5 seconds, enabling you to
exit your room before the light turns off completely.
Operation indicator
Controls the light and brightness setting.
Press and release the button to turn the light ON or OFF.
Press and hold the button to set the desired brightness.
The light button has an auto-resume, it will stay at the same brightness as
the last time it was turned off.
NOTE:
-To prevent damage to transmitter, remove all batteries if not used for long periods.
- Always replace the whole set of batteries at one time, taking care not to mix old and new ones, or
batteries of different types.
-Please contact your local batteries recycling center for proper battery disposal information.
“O” and “I” dim switch
The dim switch should be in the “I” position for dimming the light . Place the
switch in the “O” position to turn the dimming feature off.
“Sync” button
Allows receiver to pair with the code assigned by the transmitter.
“Lock/Unlock ” switch
NOTE: The transmitter has been preset in the unlock position. The
receiver has been preset with a common code. The transmitter can control
one or more fans with this initial setting.
IMPORTANT: If the remote control is not operating
correctly, please follow the steps on page 17 for
pairing. Use the corner of the battery cover to
press the "Sync" button for syncing function.