Instructions / Assembly

Fan Installation

WARNING: Failure to properly install cotter pin

could result in fan loosening and possibly falling.

Align the holes at the bottom of the downrod (B) with the

holes in the collar on top of the fan motor assembly (E).

Carefully insert the clevis pin (O) through the holes in the

collar and downrod (B). Be careful not to jam the clevis

pin (O) against the wiring inside the downrod (B).

Insert the cotter pin (P) through the hole near the end of

the clevis pin (O) until it snaps into its locked position.

Tighten two set screws (N) at top of the fan motor collar

firmly and evenly until fully engaged.

ASSEMBLE FAN

Remove the cotter pin (P) and clevis pin (O) from the

downrod of the canopy assembly (B).

Note: For installation and use of longer downrod (option

sold separately), instructions are available at

www.gelightingandfans.com

Loosen (but do not remove) the two collar set screws (N),

from the coupling on the top of the motor assembly (E).

Attach the 2-pin connectors from the downrod of the

canopy assembly (B) and motor assembly (E). Carefully

feed connectors into the downrod of the canopy assembly

(B).

To install the fan, raise the assembled fan housing up to the

ceiling receptacle (A). Press up on the push lever while lifting

the fan canopy (B) up to the receptacle (A) fully inserting the

fan plug locking pin into the receptacle locking pin terminal.

For correct alignment, make sure the mounting bracket

push lever on the canopy is placed in the middle between

the receptacle j slots as shown in the picture. Keep the

lever pushed up while turning the fan to the right (clockwise)

as shown in step 2.

Locking pin

Plug locking

Mounting bracket

push lever

J slot

rubber insert

Remove the rubber inserts located on the canopy

mounting screws (M) on both sides before installation.

HANG FAN

terminal

Place the canopy trim ring (C) on top of motor assembly (E)

and coupling cover (D) onto the downrod of the canopy

assembly (B).

2-pin connectors