Product Manual

10-6 CARESCAPE V100 Vital Signs Monitor 2036991-001C
Masimo SET SpO2: Configuration Settings Associated with SpO2
NOTES
 A patient’s vital signs may vary dramatically during the use of
cardiovascular agents such as those that raise or lower blood pressure or
those that increase or decrease pulse rate.
 The V100 Vital Signs Monitor that is labeled with Masimo SET Technology is
compatible only with Masimo SET sensors.
 Software development, software validation, and Risk and Hazard Analysis
has been performed to a registered quality system.
 User or patient-applied parts are latex-free.
Configuration Settings Associated with SpO
2
There are three configuration settings associated with this parameter: averaging
time (
n0d), FastSAT (Sat), and sensitivity mode (Sen).
Averaging Time ( n 0d) allows you to choose the number of seconds over which SpO
2
data is averaged. Choose
4 to 16 in steps of 2 (alarms are delayed by this amount).
NOTE: Increased averaging time effects time to alarm for saturation and pulse
rate limits.
FastSAT (Sat) allows you to choose 0 (for Off) or 1 (for On). If FastSAT is configured
to 1 (On), the SpO
2
values are calculated quicker.
Sensitivity mode (Sen) setting allows you to adjust the thresholds for calculating
SpO
2
values under low perfusion conditions. Choose 1 (low perfusion-
Maximized), 2 (low perfusion-Default), or 3 (adaptive probe off).
NOTE: Adaptive probe off provides a mode with enhanced detection of
"probe off " conditions. It is intended to be used if normal mode is
not detecting "probe off" with some sensors and conditions.
Buttons Associated with SpO
2
There are no buttons associated with this parameter.
Windows Associated with SpO
2
There is one window associated with this parameter: SpO
2
. While in offline
mode, nothing is displayed in the SpO
2
window. When in ready mode and the
parameter senses that a sensor is connected, a single dash (-) appears in this
window. When it is in operate mode and the parameter is reporting valid data,
the derived SpO
2
value appears in this window and updates continuously. The
values are displayed in %.
NOTE: If SpO
2
is the source for pulse rate, the Pulse Rate window is associated
with this parameter. Refer to the “Pulse Rate” Section for more
information.