Product Manual

2036991-001C CARESCAPE V100 Vital Signs Monitor 2-5
Getting Started: Setting up the Printer (Installing the Paper)
Setting up the Printer (Installing the Paper)
1. With the monitor powered on, turn it so
that the side with the printer is facing
you.
2. While grasping the side of the monitor,
lift the printer door open by placing your
thumb in the indented area and pulling.
The printer door will pop open.
3.Place the roll
of paper into the compartment so that the end of
the paper comes off the right-side of the roll (paper
is wound around the roll clockwise). Push the roll all
the way to the back of the printer cavity, making
sure the paper extends out of the printer cavity at
least two inches.
4.Firmly press the door to close it.
Power Sources
The V100 Monitor is designed to operate from an internal battery (see
Specifications in “Product Overview” Section). The V100 Monitor is not designed
to operate without an internal battery. With external DC power connected, the
green CHARGING indicator will light to indicate that the battery is charging.
NOTES
 Prior to each use, inspect the power supply cord to ensure proper
connection and condition.
 Be sure to unplug the power supply from the AC outlet before transport.
Turning the Monitor On and Off
To turn the V100 Monitor on, push the power On/Off button. As the monitor
powers up, it runs a short self-test (display test) in which all seven-segment
indicator lights illuminate. When the monitor is powered on, it generates a start-
up sound. This start-up sound consists of 5 separate tones generated in
succession.