24988 IR Extender Kit Instruction Manual
The IR Extender Kit connects IR Hub, IR Receiver, IR Emitter, and Power Supply together to interface the IR system to the audio/video components.
Features 1. Blue IR confirmation LED. 2. Wide band IR receives IR from many type of remotes. 3. Self-adhesive tape for quick and easy fixing on any flat surface. 4. 3 meter cable with 3.5mm stereo mini-plug. Instructions 1. Power Connect the 12 VDC (500mA) power supply to the power jack of the IR HUB. The red LED will be illuminated when powered. This will power all of the IR components connected to the system. 2.
Before installing the emitter and IR receiver, thoroughly clean the surface. A. Standard and Preferred installation 1. The preferred method is to attach the IR emitters directly to the IR sensor window on electronic device. 2. To locate the IR sensor on your electronic device, you may have to use a flashlight to shine into the front of the component through the glass to find the sensor. The sensor may be a square or round circle depending on the manufacturer of the electronic device.
C. Cabinet with door installation 1. It may be needed to attach emitter on the inside of the cabinet door. This method will flood the area with infrared signal for the component to receive. 2. Place the emitter directly in front of the component on the door and press firmly with the round shape facing the IR sensor. D. Installing the IR Receiver 1. Locate a flat surface on the front of your television or cabinet. Peel the adhesive backing and press firmly on the desired location. 2.
b. c. d. It may also be due to a peculiar RCU / sensor combination. Placing the emitter 2” - 4” away from the IR sensor can achieve significantly better activation in such cases. Please experiment to achieve optimal activation before securing with the self-adhesive pads. Some flat panel TVs emits interference for the IR receiver to receive signals. Placing the receiver up to 6” away from the front of the TV may allow the receiver to better receive IR signals.
FCC This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
