Full Product Manual

12
3. Press and release the
MUTE button.
4. Press and release the VOL - button.
The red indicator light
will blink twice and go off.
To make sure the Master Volume Feature
is disabled, put the remote in TV mode if
youprogrammedthecableboxtobethe
Master Volume Device. Point the remote
at the TV and press a volume button.
If the volume changes on the TV, the
feature is disabled. If the volume on the
cableboxchanges,andnottheTV,you
will have to repeat the steps above and
test again.
Reset to Factory Settings
1. Press and hold the SETUP button
until the red indicator stays on
(approximately2seconds)andthen
release the button.
2. Press and release the OK button.
3. Press and release the number #0
button. The red indicator light will
flash twice.
Master Volume Feature, cont.