SDS

IDH number: 2749483
Product name: GE ALL PURPOSE SILICONE W<(>&<)>D PROJECTS
Page 2 of 5
Ingestion:
DO NOT induce vomiting unless directed to do so by medical personnel.
Never give anything by mouth to an unconscious person. Seek medical
attention immediately.
Symptoms:
See Section 11.
5. FIRE FIGHTING MEASURES
Extinguishing media:
Foam, dry chemical or carbon dioxide.
Special firefighting procedures:
Wear self-contained breathing apparatus and full protective clothing, such as
turn-out gear.
Unusual fire or explosion hazards:
Closed containers may rupture (due to build up of pressure) when exposed to
extreme heat. In case of fire, keep containers cool with water spray.
Hazardous combustion products:
Oxides of carbon. Oxides of silicon. Formaldehyde. Toxic and irritating vapors.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and
unprotected personnel.
Environmental precautions:
Do not allow product to enter sewer or waterways.
Clean-up methods:
Ensure adequate ventilation. Wear appropriate personal protective equipment.
Refer to Section 8 "Exposure Controls / Personal Protection" prior to clean up.
Soak up with inert absorbent material (e.g. sand, silica gel, acid binder,
universal binder, sawdust). Scrape up spilled material and place in a closed
container for disposal.
7. HANDLING AND STORAGE
Handling:
Avoid contact with eyes, skin and clothing. Do not wear contact lenses. Do not
handle contact lenses until all sealant has been removed from hands.
Residual sealant may transfer to lenses and cause eye irritation. Vapours
should be extracted to avoid inhalation. Wash thoroughly after handling. See
Section 8 of the SDS for Personal Protective Equipment. Use only with
adequate ventilation. Keep container closed.
Storage:
Keep in a cool, well ventilated area away from heat, sparks and open flame.
Keep container tightly closed until ready for use.
For information on product shelf life, please review labels on container or check the Technical Data Sheet.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper
exposure controls and protective equipment for each task performed.
Hazardous Component(s)
ACGIH TLV
OSHA PEL
AIHA WEEL
OTHER
Silicon dioxide, crystalline
6 mg/m3 TWA
20 MPPCF TWA
0.8 mg/m3 TWA
None
None
Titanium dioxide
10 mg/m3 TWA
15 mg/m3 PEL Total
dust.
15 MPPCF TWA
Respirable fraction.
15 mg/m3 TWA Total
dust.
50 MPPCF TWA
Total dust.
5 mg/m3 TWA
Respirable fraction.
None
None
Engineering controls:
Use local ventilation if general ventilation is insufficient to maintain vapor
concentration below established exposure limits.
Respiratory protection:
Use NIOSH approved respirator if there is potential to exceed exposure
limit(s).