Full Product Manual

c) Ground the 75 OHM Grounding Block: Connect

a #8 aluminum or #10 grounding wire to a screw

terminal provided on the 75 ohm grounding block.

Connect the other end of the wire to an acceptable

building ground location. Refer to step a) in this section

for acceptable building grounding locations.

Be sure to double check all your connections after

your installation is complete. Ensure there are good

electrical connections of your grounding wires and

coax cables. See Fig. 6d below for an example of a

properly grounded antenna installation.

Example of Antenna Grounding

as per NEC - National Electrical Code

ELECTIC SERVICE METER PANEL

POWER SERVICE GROUNDING ELECTRODE SYSTEM

(NEC ART 250. PART H)

GROUNDING CONDUCTORS

(NEC SECTION 810-21 )

GROUND CLAMPS

75 OHM GROUNDING BLOCK

(NEC SECTION 810-20)

ANTENNA COAX

RAIN DRIP LOOP FOR THE COAX TO TV

Fig. 6d

If you are unsure how to properly ground your antenna

installation, contact a professional installer in your area.

d) Danger Label Application: If your antenna mounting

structure, such as a mast, J-Mount or pole, does not

have a danger label, apply the danger label provided

to the base of the mounting structure in a clearly

visible location.