Use and Care Manual

6
7
Adding a Signal Repeater
Step 1 - Find an
electric outlet
near the Sensor
having trouble
communicating
with the Control
Center. Make
certain the location
is between the
Sensor and Control
Center. Plug the
Signal Repeater
into the outlet and press the ‘Test’
button on the side of Signal Repeater.
It will send a test signal out to the
Control Center and the LED indicator
on the Signal Repeater will flash rapidly
for about one second, then go out.
Step 2 - When the Control Center
receives the Signal Repeater’s test
signal, it will flash the green power
indicator. This means a confirmation
signal was sent back to the Signal
Repeater. Release all buttons.
Test