Use and Care Manual

6
7
Step 3 - When the Signal Repeater
receives the confirmation signal, the
LED indicator will flash, five times. If
the Signal Repeater does not receive
the confirmation signal from the
Control Center, the LED indicator on the
Signal Repeater will not flash. You will
need to move the Signal Repeater
closer to the Control Center and retest.
Step 4 - To Ensure the Signal Repeater
can receive the signal from the
Sensor, activate the Sensor. The Signal
Repeater’s LED indicator should flash
rapidly, and the Control Center should
respond to the Sensor’s signal.
This process will help you locate the
Signal Repeater to the best (farthest)
position from the Control Center in
order to extend the range of
the Sensor.