User Manual

2. Remove the small screw from
the battery retainer door. Pull
out on the top of the door (it is
hinged at the bottom).
3. Slide the batteries out of the
holder.
4. Install new batteries in the
correct orientation based on
the “+” & “-“ polarity markings
5. Hold the batteries in place
(pushing them toward the
center of the unit) and close
the battery door making sure
that the ends of the retainer
door fit over the batteries.
Please note that the battery
retainer door hinges at the
bottom and can lock in the
open position. You may need
to pull or lift it gently to close it.
6. Reinstall the retainer screw
and faceplate.
Battery Life: This device is just like any
universal A/V remote control;
the more you use it, the shorter the
battery life. Under normal operating
conditions, the batteries should last
for approximately one year. LED
indicators behind the Group/Scene
control buttons will blink when one of
the buttons is Pressed. The brightness
of the blinking LED will diminish as the
batteries are depleted. A very dim
LED will provide a visual indication
that the batteries need to be replaced.
Network, Group & Scene programming
will be retained while changing
batteries. Please note: Using this
device to control Groups and Scenes
containing large numbers of Z-Wave
devices will be more demanding on
the batteries than smaller Groups and
Scenes, resulting in shorter battery life.
NOT FOR USE WITH MEDICAL OR LIFE
SUPPORT EQUIPMENT
Z-Wave enabled devices should never
be used to supply power to, or control
the On/Off status of medical and/or life
support equipment.