- General Electric Deep Steam Carpet Cleaner Owner's Guide

Lift

Latch

HOW TO Prepare The Carpet Shampooer/

Extractor For Carpet Cleaning

IMPORTANT: For best results, begin with a clean surface by vacuuming surface or item before using the

carpet shampooer/extractor.

A. Fill the Clean Water Solution Tank

1) Lift up the tank latch to release the clean water solution tank.

2) Grasp the carrying handle on the clean water solution tank and

remove it from unit.

3) Remove cap and add 4 ounces of Genuine GE carpet/upholstery

shampoo to the tank.

4) Fill tank to the designated fill line with warm tap water, not to

exceed 120°F, replace cap (see diagram).

5) Place clean water solution tank into the carpet shampooer/

extractor unit by

a) place the bottom of tank into the reservoir.

b) gently push upper portion of tank into unit until it snaps

securely into place.

Fill Line -

1 Gallon

NOTE: When moving the carpet shampooer/extractor from one location to another, always make sure the

recovery and clean water solution tanks are completely empty. Then tilt the unit slightly backward and

roll on rear wheels or use the carpet shampooer/extractor’s carrying handle for transporting up and

down stairs.

NOTE: Mix cleaning solution properly to avoid

damage to carpet and upholstery.

NOTE: FAMILIARIze yourself with the parts of the

carpet shampooer/extractor by reading this

owner’s manual before using.

Carrying

Handle

Tank Latch