RM24927 RM94927 Universal Remote Instruction Manual
Table of Contents Introduction ........................................................... 3 Setup .................................................................... 3 Battery Installation ........................................... 3 Battery Saver ................................................... 3 Code Saver ...................................................... 3 Code Setup ...................................................... 3 Button Functions .............................................
Button Functions Some buttons on the remote might have functions that are referred to by different names on the device you are controlling. E.G. PREV.CH may be called RECALL, or ENTER may be called DISPLAY. These differences depend on the brand and model of your product. Also, this remote can only operate features that exist on your product. E.G., your product must have PREV.CH ability for the PREV.CH button to operate this feature. TV, VCR, etc. Red Indicator CODE SEARCH Selects product For setup.
Audio Button Descriptions Press the AUDIO device button to enable the AUDIO MODE. Audio functions are indicated by the blue button descriptions. LEVEL+/LEVEL- Sets the level of the speakers during test tone mode. DSP ON•OFF Enables the receiver’s Digital Sound Processing mode. DSP MODE When the DSP mode is enabled, pressing this button lets you toggle through the various DSP modes. CD, TAPE, TUNER, TV, VIDEO Used to directly select the device you want to control. (Works in AUDIO mode).
Surround Sound Feature The surround sound feature may be turned ON/OFF by pressing the SURR ON•OFF button. 1. Press the SURR MODE button until the desired mode is found. 2. Press DELAY+ or DELAY- to achieve the desired delay affect. 3. Press the DSP ON•OFF button to turn DSP (Digital Sound Processor) ON or OFF. 4. Press the DSP mode button until the desired effect is achieved. 5. Press the TEST button to listen to speaker levels. 6. Press FRONT, CENTER, or REAR buttons to select speakers. 7.
Code Search Using Your Remote If your device does not respond after you have tried all the codes for your brand, or if your brand is not listed, try searching for your code by following these steps. 1. Manually turn on the device (TV, VCR, etc.) to be controlled. 2. Press and hold the CODE SEARCH button until the red indicator stays on, then release the CODE SEARCH button. 3. Press and quickly release the desired device button (TV, VCR, etc.). The red indicator blinks off once. 4.
Using Your Remote, cont. Sleep Function Using Your Remote, cont. Controlling Devices with Separate Power On and Off Buttons The Sleep button enables the remote to turn off your TV after a period of 1 to 99 minutes as shown below. The remote must be in TV mode to set a Sleep Timer. This feature works even if your TV does not have a sleep feature.
Using Your Remote, cont. Using Your Remote, cont. Volume/Mute Control and PunchThrough Setting any Mode to use its own Volume/Mute Control This remote lets you select which device Mode controls your Volume/Mute buttons. The remote is initially set for all device Modes to use their own Volume/Mute control if present. If the programmed code has no Volume/Mute operation of its own then those buttons will punch-through control to the TV Mode device without needing to change to TV Mode.
Troubleshooting Remote does not operate your product. • • • • Press the device button of the product you want to control. Program the remote with a new code. Install new batteries. (You might have to reprogram your remote after installing new batteries.) Remote may not be compatible with your product. Remote does not operate some features of your product. • • Sometimes a particular code might operate some features but not all. Try programing remote with a new code.
RM24927 RM94927 Universal Remote Instruction Manual Jasco Products Company 311 N.W.
