Installation guide

TOOLS YOU WILL NEED:
• Phillips-head screwdriver
• 1/4" and 5/16" nutdriver
• 6" Adjustable wrench
• Level
• Carpenter's square
• Measuring tape
• Safety glasses
• Flashlight
• %XFNHWWRFDWFKZDWHUZKHQÀXVKLQJWKHOLQH
• 15/16" socket (optional for skid removal)
• Gloves
• Pliers
For New Installations Only:
• Tubing cutter
• Drill
• 1-1/2" Hole saw
Hot Water Line
Hand
6KXW2ȹ
Valve
Side Trim Pieces
(on some models)
Hole Saw Set
Level
Thread
Seal Tape
(if applicable)
Air Gap
Strain Relief
Drain Hose
Hose
Clamp
Insulation
#8 Hex-Head
Mounting
Bracket
Screws
1/4" and 5/16"
Nutdriver
15/16" Socket
Bucket
Tubing Cutter
Drill and Bits
Flashlight
Phillips-Head
Screwdriver
Carpenter's
Square
6"
Adjustable
Wrench
Safety Glasses
Pliers
Installation Preparation
2
Drain Hose Hanger
Toekick
Measuring Tape
PARTS SUPPLIED
IN INSTALLATION PACKAGE:
• Junction box cover and #10 hex-head screw
• Hose clamp
• Drain hose (approximately 58" long)
• Drain hose hanger
• 2 #8-18 hex head screws to secure brackets to washer tub frame
• 2 Plug buttons
• Toekick (pre-installed on some models)
• 2 side trim pieces (some models)
• 2 mounting brackets for wood countertops or side cabinets
• 2 #8-18 x 5/8" Phillips special head screws, to secure dishwasher
to underside of countertop or to side cabinets
• Insulation pieces (some models)
• Literature, samples and/or coupons
MATERIALS YOU WILL NEED:
• *+7*DUGHQ+RVH7KUHDGÛHOERZ
(including gasket) - with opposite end sized to fit
Hot Water Line
• Thread seal tape
• UL-listed wire nuts (3)
• Masking Tape
Materials Needed for
New Installations:
• Air gap for drain hose, if required
• Waste tee for house plumbing, if applicable
• Electrical cable or power cord kits WXO9X70910
(5' 5" long) or WX09X70911 (7' 11" long) only
• Screw-type hose clamps
• Strain relief for electrical connection
• Hand shut-off valve (recommended)
• Hot water line–3/8" minimum, copper tubing
(including ferrule, compression nut) or
GE Part # WX28X326, flexible braided hose
• WD24X10065 drain hose (12' long), if needed
Junction
Box Cover
#10
Hex-Head
Junction
Box Screw
1/2" long
Optional
12' Drain Hose
Hose Clamps
Waste Tee
Electrical Cable
(or Power Cord, if applicable)
Wire Nuts (3)
Mounting
Brackets
#8 Phillips
Special
Head Screws
5/8" long
Plug Buttons
GHT 90° Elbow
Masking Tape
(if applicable)
Coupler for
optional drain
hose
Gloves