Installation guide

STEP 6: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp
as shown in the figure.
STEP 5: INSTALL 90° ELBOW
Dishwasher Installation
7
STEP 8: INSTALL DRAIN HOSE,
THROUGH CABINET
• Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate cabinet opening.
STEP 7: POSITION WATER LINE
AND HOUSE WIRING
• Position water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Water
Line
House
Wiring
4"
4"
6"
6"
7LS3UHYHQWXQQHFHVVDU\VHUYLFHFDOOFKDUJHVIRU¿OOGUDLQ
or noise concerns.
• Position utility lines so they do not interfere with anything
under or behind the dishwasher.
• Reposition the insulation blanket over the collar, as shown.
Water Valve
Bracket
90° 3/4"
GHT Elbow
Fill Hose
Front of dishwasher
• Thread 3/4" GHT 90°
elbow onto water valve.
Ensure rubber gasket is
located between valve
and elbow.
• Do not overtighten
elbow. Water valve
bracket could bend or
water valve fitting could
break.
• Position the end of the
elbow to face the rear of
the dishwasher.
House
Wiring
Power Cord
(If used)
Drain
Hose
Water
Line
Insulation
Blanket
Ensure drain hose is not
twisted or pinched
Maximum drain hose
length is 15'
Do not disconnect or remove high
drain loop from left side of dishwasher
Pull insulation
blanket over
collar