User manual

– 28 –
Door Disassembly
1. Remove the door (see procedure).
2. Insert a small flat screwdriver into the gap
between the choke cover and the lower right
corner of the door frame, then work the
screwdriver around the seal plate to free
engaging parts of the choke cover.
3. Lift up the latch until the pins clear the
mounting holes.
4. Disconnect the spring and remove the latch.
5. Remove 2 screws and the door handle.
Cooktop Light
1. Remove 1 screw and lower the light cover.
GEA00985
Cooktop Light CoverCooktop Light Cover
ScrewScrew
Caution: Light bulb is 12-volt, 20-watt. Bulb is
plug-in type, do not twist.
2. Pull the bulb out of the receptacle.
Oven Light
1. Remove the grille (see following procedure).
GEA01003
ScrewScrew
ScrewsScrews
Cover PanelCover Panel
Convection
Fan Cover
Convection
Fan Cover
2. Remove the cover panel.
3. Slide the light assembly toward the oven door
to disengage it from the locked position, lift the
assembly, and turn it over to access the bulb.
Caution: Light bulb is 12-volt, 10-watt. Bulb is
plug-in type, do not twist.
4. Pull the bulb out of the receptacle.
Vent Cover
1. Remove the grille (see procedure).
GEA00991
Screws
Screws
Screws
Vent Cover
Vent Cover
Vent Cover
2. Remove 2 screws and the vent cover.