User manual

– 32 –
Capacitor and Diode
WARNING: Always be certain the capacitor is
discharged before servicing. Mechanically
discharge by placing an insulated handle
screwdriver between the diode connection of the
capacitor and the oven chassis ground.
Note: The high voltage capacitor has an internal
discharge resistor that automatically discharges
the capacitor when the oven turns OFF. Under
normal operation, the capacitor should fully
discharge within 30 seconds.
• The case may be removed to provide greater
access to the capacitor and diode.
1. Remove the grille and vent cover (see
procedures).
2. Remove the sub PCB (see procedure).
3. Disconnect the wire leads from the capacitor.
GEA00998
Screw
Screw
Screw
Capacitor
Capacitor
Capacitor
Capacitor
Capacitor
Capacitor
Power Cord
Power Cord
Power Cord
Outer Case Removed FOR CLARITY
4. Remove 1 screw from the capacitor mounting
bracket and lift the bracket up to disengage the
bottom tab from the chassis. Remove the
bracket and capacitor.
5. Remove the capacitor and diode from the
mounting bracket.
Magnetron TCO
1. Remove the control panel to access the
magnetron TCO, wiring, and screw through
control panel opening (see procedure).
GEA01011
Magnetron
TCO
Magnetron
TCO
2. Disconnect the wire leads from the magnetron
TCO.
3. Remove 1 screw and the TCO bracket from
the magnetron.
4. Remove 1 screw and the TCO from the
bracket.
Hood TCO
1. Remove the control panel (see Procedure).
GEA00984
Wire LeadsWire Leads
Hood TCOHood TCO
ScrewScrew
2. Disconnect the wire leads from the hood TCO.
3. Remove 1 screw and the TCO.