0 GEAppliances.com Safety Information ........ Operating/Care and Cleaning Instructions Charcoal Filter ................... Grease Filter ..................... Hood Light ....................... Hood Surfaces ................... Controls ......................... Installation Instructions ................ Consumer Support consumer support ...... Warranty .......................
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS A WARNING- TO REDUCE THE RISK OF FIRE, A WARNING- TO REDUCE THE RISK OF ARANGE ELECTRIC SHOCKORINJURYTOPERSONS, OBSERVE THE FOLLOWING: TOPGREASE FIRE: A. Usethis unit only in the manner intendedby the manufacturer.If you havequestions,contact the manufacturer. A. Neverleavesurfaceunits unattended at high settings.Boilovers causesmokingand greasyspilloversthat may ignite.Heat oils slowlyon low or medium settings. B.
INSTRUCTIONS LISEZ TOUTES DE SECURITE IMPORTANTES. LES INSTRUCTIONS AVANT D'UTILISER. PRdLCAUTIONSEN NATI_LREDE SdLCURITdL AA VERTISSEMENT - POUR R_DUIRE LE A. Ne laissezjamais sans surveillance lesunit@sde cuisson de surface RISQUED'INCENDIE,DE SECOUSSEE-LECTRIQUE OU DE BLESSURE CORPORELLE, OBSERVEZLESPRECAUTIONSSUIVANTES: A. N'utilisezcet appareil que de la mani_re pr@ue par lefabricant. Si vous avez des questions,appelez lefabricant. B.
Using the hood controls. Throughout Control this manual, features and appearancemay vary from your model. Knobs Switch (on some models) Pad Controls (on some models) ON OFF oN NITE , HI OFF e l _OFF J OFF LO (AV447 models only) FAN Control LIGHT Control Turn to HI, PIED or LO as needed. Press the pad at the top to turn the light ON. Continuous use of the fan system while cooking helps keep the kitchen comfortable and less humid.
Charcoal Filter--Recirculating Replaceable charcoal filter NOTE: DO NOT rinse, or put charcoal filters in an automatic dishwasher. Installations The charcoal filter cannot be cleaned. It must be replaced. Order filter no. WBO2XI0700. Replacementfilters can be orderedfrom your GEsupplier. tf the hood isnot ventedto the outside,the air will be recirculatedthrougha disposable charcoalfilter that helpsremovesmokeand odors.
I stall ti I str cti Ra e Hood $ BEFORE YOU BEGIN DUCTWORK Read these instructions completely and carefully. NOTE:Read the ductwork sections only if you do not have existing ductwork. If you have existing ductwork, skip to the °'Damage" section and proceed. • IMPORTANT - Save these instructions for - Observe all governing local inspector's use.
Installation WORKSHEET--CALCULATE DUCT TOTAL EQUIVALENT DUCTWORK LENGTH EQUIVALENT LENGTH NUMBER x USED = 31A" x !0" Rect., straight 1Ft. x ( = 7" Round, straight 1Ft. 6" Round, straight 1Ft. Rect. 31A"x 90 !0"° elbow 14 Ft. PIECES Instructions x ( x ( x ( ) ) ) ) DUCT = = = TOTAL Ft. Ft. Ft. Ft. Rect. 31A'x 45 !0"° elbow 8 Ft. x ( ) : Ft. i_ Rect. 31A'x 90 !0"° flat elbow 33 Ft. x ( ) : Ft. _ 31A'x !0" Rect. wall cop with 24 Ft. (18 ft.
Installation Instructions DAMAGE - SHIPMENT/INSTALLATION TOOLS YOU WILL NEED • If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or replacement. • If the unit is damaged by the customer, repair or replacement is the responsibility of the customer. Flat-blade and Phillips screwdrivers Pencil Duct tape • If the unit is damaged by the installer (if other than the customer), repair or replacement must be made by arrangement between customer and installer.
Installation [] Instructions CHOOSE VENT OPTION IMPORTANT: If the hood is to be installed in a recirculating, non-vented, ductless manner, do not knock out any vent openings in the hood. Only an electrical access hole will be knocked out of the hood. Determine the vent option that your installation will require and that is available for your model from the below choices.
Installation [_] REMOVE EXHAUST Instructions _-] REMOVE WIRING COVER ADAPTOR If exhausting/venting using the 31/W'x 10" rectangular duct--optional for JV247, JV248, JV338, JV347, JV348, JV367 and AV447 models only: Remove the exhaust adaptor from the inside of the hood. Set it aside along with its mounting screws. Remove the wiring cover from inside the hood. Set the cover and its mounting screws aside.
Installation Instructions i-8-IFOR 3-1-4" × I0" RECTANGULAR DUCTED DISCHARGE INSTALLATIONS ONLY: ITO]FOR RECESSED-BOTTOM ONLY Attach exhaust adaptor/damper over the appropriate knockout opening (for vertical or horizontal, depending on installation) with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back edge of hood. Remove tape from damper flap.
Installation [] Instructions MARK HOLES C.Outside rear exhaust Select the vent option that your installation will require and proceed to that section: A.Outside top exhaust (Vertical duct-3-1/4" (Horizontalduct-3-1/4" x 10" Rectangular) . Use the diagram or the hood as a template and mark the locations on the cabinet for ductwork, electrical wiring and keyhole screw slots. x 10" Rectangular) Wood shims .
Installation [] Instructions SCREW IN PART WAY [] SECURE HOOD Drive a mounting screw (from the hardware packet) part way into each center of the narrow neck of the keyhole slots marked on the cabinet bottom. Slide the hood back against the wall. Tighten the mounting screws. Be sure the screw heads are in the narrow neck of the keyhole slot.
Installation [] Instructions [] INSTALL LIGHT BULB REPLACE WIRING COVER NOTE:A light bulb is not shipped with the hood. Obtain one locally. Purchase and install a type A15 incandescent light bulb with an ordinary screw base, not more than 60 Watts, or a type A17 or T2 Compact Fluorescent (CFL)light bulb with an ordinary screw base, not more then 13 Watts. NOTE:Useonly incandescent bulbsin modelsRN328,JN327 and JV338.
GE Range Hood Warranty. All warranty service provided by our Factory Service Centers, or an authorized Customer Care ® technician. To schedule service, visit us on-line at GEAppliances.com, or call 800.GE.CARES (800.432.2737). Please have serial number and model number available when calling for service. Staple your receipt here. Proof of the original purchase date is needed to obtain service under the warranty.
Consumer Support. Ii GEAppliances Website GEAppliances.com Have a question or need assistance with your appliance? Try the GEAppliances Website 24 hours a day, any day of the year! Forgreater convenience and faster service,you can now download Owner's Hanuals, order parts or even schedule service on-line. Schedule Service GEAppliunces.com Expert GE repair service is only one step away from your door. Get on-line and schedule your service at your convenience any day of the year! Or call 800.
