User Manual

Installation Instructions

INSTALLING THE ZONELINE (cont.)

3. INSTALL THE UNIT INTO

THE WALL CASE

Slide the unit into the wall case and secure with four

screws through the unit flange holes.

The four screws will be located in a sealed bag that

sits under the control panel, sitting in the pocket in the

basepan.

5. REPLACE THE ROOM

FRONT

Reinstall the room cover by aligning and placing the top

rail of the room cover over the chassis (1), then pushing

it in at the bottom (2).

NOTE: There are several extra holes in the unit side

flanges for installation in wall cases other than GE.

To avoid damaging the flange insulation, the installer

should use an awl or other sharp tool to puncture the

insulation in the appropriate holes before installing the

attachment screws.

The four wall case screws will be taped

to the pocket in front of the control box.

. CONNECT POWER CORD

OR DIRECT CONNECT KIT

Review installation instructions provided with power

cord or direct connect kits for detailed assembly

instructions.

Power supply kit

(Appearance may vary)