Installation guide

Installation Instructions
STEP 14 CONNECT WATER SUPPLY
Connect water supply line to the 90° elbow.
• Slide compression nut, then ferrule over end of water line.
• Insert water line into 90° elbow.
• Slide ferrule against elbow and secure with compression nut.
IN PORTANT- Check to be sure that door spring
does not rub or contact the fill hose or water supply line. Test
by opening and closing the door. Reroute the lines if a rubbing
noise or interference occurs.
Figure EE
Compression Nut
Ferrule
Hot Water
_0° Elbow Supply Line
o
\ Door Spring
STEP 3.5 CONNECT DRAIN LINE
FOLLOWALL LOCAL CODESAND ORDINANCES.
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fit
the inlet port.
Cutting Line IMPORTANT: Do not cut corrugated
_/ portion of hose
Figure FF
connection with
hose clamps.
Figure GG
• If a longer drain hose is required, add up to 42" of length for
a total of 10' to the factory installed hose. Use 5/8" or 7/8"
inside diameter hose and a coupler to
connect the two
hose ends.
Secure the
Coupler
Hose Clamp
Hose Clamp
• Securethe drain hose to the air gap, waste tee or disposer
with clamps.
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR
PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
Method 1 - Air gap with waste tee or disposer
Insert the drain hose to air gap as shown.
Waste Tee Installation
Figure HH
Disposer Installation
Method 2 - Drain Hose Routing
Route the drain hose of the dishwasher to a minimum height of 32" from
the floor with the supplied hanger as shown.
_ j"_a
Figure JJ
Disposer Installation
IMPORTANT- Eitherone oftheabovemethods
must be used or dishwasher will not operate properly.
IMPORTANT- Whenconnecting
drain line to disposer, check to be sure
that drain plug has been removed.
DISHWASHERWILL NOTDRAINIF
PLUGISLEFTIN PLACE.
[_ Remove
Hopper
Plug
Tip: Avoid unnecessary servicecallcharges.Always be sure
disposerdrainplug has been removed beforeattaching
dishwasher drainhose to the disposeE
io