Dimensions Guide

Specification Created 1/15
For answers to your Monogram,
®
GE Profile
™
or GE
®
appliance questions, visit our website
at geappliances.com or call GE Answer Center
®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
To insure accuracy, it is best to make a
template when cutting the opening in the counter
Electrical junction box 16" MIN.
below countertop
Cooktop
36"
20-7/8"
18-7/8"
33-3/4"
19-1/8" to
19-1/4"
33-7/8"
to 34"
CHP9536SJ
2-1/2" MIN.
Required
1-3/4" MIN.
to rear wall
4-5/8" at baffle near center
ofunit (except when installed
above an approved wall
oven) and 3-1/4" at rear
of air intake
13" MAX. depth of unprotected
overhead cabinets (when no
hood or microwave is installed)
30" MIN. from countertop to
unprotected cabinet (when
no hood or microwave is
installed)
2" MIN. clearance
to side wall from cut-out
on both sides of cooktop
15" MIN. height from countertop
to nearest cabinet (including
light rails) on both sides of
cooktop
See label next
to nameplate for
MIN. clearance
to wall
Important: Requires a 5" free area between
the bottom of the cooktop to any combustible
material, i.e., shelving. Free area not required
when installing wall oven underneath cooktop.
Refer to installation instructions. Requires
a 15" minimum from cooktop to adjacent
overhead cabinets. Units are furnished with a
48" flexible armored cable.
note: 36" induction cooktops are approved
for use over select GE 30" Single Wall Ovens
and Warming Drawers. Refer to cooktop
and wall oven/warming drawer installation
instructions packed with product for current
dimensional data. If installed with a GE
Telescopic Downdraft System, consult both the
cooktop and downdraft installation instructions
packed with product before installing. Cooktop
gas/electric supply may need to be re-routed
to install downdraft. The countertop cutout
requires 23-1/2" minimum flat countertop
surface and 25" minimum total countertop
depth. In addition, other clearances to front
edge of the countertop must be considered.
Before installing, consult installation
instructions packed with product for
current dimensional data.
DImensIons anD InstallatIon InformatIon (In Inches)
chp9536sJ
GE Café
™
Series 36" Built-In Touch Control Induction Cooktop
KW Rating
240V 11.1
208V 9.6
Amperage
240V 46.3 Amps
†
208V 46.3 Amps
†
†
note: Check local codes
for required breaker size
approxImate cookIng DImensIons