Manual
16 49-80819
INSTALLATION PREPARATION
Installation Instructions
2B
Alternate Mounting Method
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
SKIP THIS STEP IF USING WALL MOUNTING
METHOD
When necessary, the hood may be installed so that it
is supported by the soffit.
Ŷ 7KHVRIILWVKRXOGEHFRQVWUXFWHGZLWK[¶V
Ŷ 'HWHUPLQHWKHLQVWDOODWLRQORFDWLRQRQWKHZDOO
Ŷ &RQWLQXHWKHFHQWHUOLQHIRUZDUGRQWKHERWWRPRIWKH
cabinet or soffit.
Ŷ 7KHRSHQLQJDERYHWKHKRRGVKRXOGDOORZIRUWKH
10" round duct and clearance to slide the hood back
against the wall.
Ŷ 7KH[VWXGVPXVWEHORFDWHGDVVKRZQLQWKH
chart, Dim. A. to accept mounting screws.
“A” Centerline to Stud
and Keyhole Slots
“B” Hood Width At
the Top
CV48S 23-9/16" 47-15/16"
Ŷ 'ULOOSLORWKROHVLQWRWKHVWXGVDWWKHORFDWLRQV
shown in the top view illustration.
IMPORTANT: Soffit framing must be capable of
supporting up to 150 lbs.
Ŷ 8VHGXFWWDSHWRVHDOWKHWUDQVLWLRQGXFWFRQQHFWLRQ
Check to be sure the damper moves freely.
Mount Hood onto Soffit or Cabinet
NOTE: If mounting to the underside of a cabinet with a
recessed bottom, install shims to fill the gap.
Ŷ 'ULYHPRXQWLQJVFUHZVLQWRWKHVWXGVXQWLOWKH\
protrude 1/4". The 1/4" gap will provide clearance to
engage the keyhole slots in the top of the hood.
Ŷ /LIWKRRGWRLQVWDOODWLRQSRVLWLRQ/RFDWHKRXVHZLULQJ
and route through the knockout (from the back or
top of the hood).
Ŷ /LIWKRRGRQWRPRXQWLQJVFUHZV6OLGHEDFNDJDLQVW
the rear wall.
Ŷ 7LJKWHQPRXQWLQJVFUHZV
IMPORTANT: For additional support and to
minimize vibration during operation, the hood must
be secured to the back wall. Use wall anchors to
fasten bottom back of hood to the wall.
A
Requires 10-1/2" Min.
Opening For Ductwork
and Hood Installation
A
2"
7-1/2"
A
B
2-9/16"
10"
3/4"
Back of Hood
Top View
Front of Hood
1/4" Gap
Push Back
to Wall
Add Shims
If Bottom
Is Recessed
Back
Wall
Cabinet
or
Soffit
Engage Top
Keyhole Slots