Installation Guide

ManualsBrandsGE ManualsIndoor FixturesGE DI Series Square Wall Wash

Lighting

imagination at work

(DI Series)

Lumination

LED Luminaire

Installation Guide

BEFORE YOU BEGIN

Read these instructions completely and carefully.

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF ELECTRIC SHOCK

• Follow all NEC and local codes.

• Use only UL approved wire for input/output connections.

Minimum size 18 AWG or 14 AWG for continuous runs.

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL pour les entrées/sorties de

connexion. Taille minimum 18 AWG ou 14 AWG pour les rangées continues.

Save These Instructions

Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.

Prepare Electrical Wiring

Electrical Requirements

• The LED driver must be supplied with 120V for

DIXXXXXXX1VXX xtures, 277V for DIXXXXXXX2VXX

xtures, and 347V for DIXXXXXXX3VXX xtures,

50/60 Hz and connected to an individual properly

grounded branch circuit, protected by a 20 ampere

circuit breaker. Use min. 75°C supply conductor.

Grounding Instructions

• The grounding and bonding of the overall system shall

be done in accordance with National Electric Code

(NEC) Article 600 and local codes.

Summary of content (4 pages)

PAGE 1
Installation Guide GE Lighting Lumination LED Luminaire TM (DI Series) BEFORE YOU BEGIN Read these instructions completely and carefully. WARNING/AVERTISSEMENT RISK OF ELECTRIC SHOCK • Turn power off before inspection, installation or removal. • Properly ground electrical enclosure. RISK OF ELECTRIC SHOCK • Follow all NEC and local codes. • Use only UL approved wire for input/output connections. Minimum size 18 AWG or 14 AWG for continuous runs.
PAGE 2
Unit Installation 1 Fixture Hole Size 4 in. round fixture 5 in. (126mm) diameter hole 6 in. round fixture 6½ in. (165mm) diameter hole 4 in. square fixture 5½ in. x 5½ in. (140mm x 140mm) 6 in. square fixture 7 in. x 7 in. (178mm x 178mm) Cut the appropriate size hole into ceiling tile (see table at right). T-Grid T-Grid 2 Slide hanger bars through adjustable mounting brackets. 3 Option A: Mount fixture by attaching hanger bars to T-Grid ceiling (BH3 SKU 94890).
PAGE 3
Electrical Connections 0-10V dimming controller (optional) Connect the black (line) of the AC line to the black 120V, 277V, or 347V wire. Connect the white (neutral) wires of the AC line to the white wires using the provided 18-12 AWG push-in connectors. Connect the green wire to the ground screw. From module holder Thermal protector Optional: If using a 0-10V dimming controller, connect matching-colored wires together.
PAGE 4
Troubleshooting Symptom Solution Luminaire does not light • Check input voltage and check power supply input/output connections. • Check circuit breaker. • Check that the color of the supply side wires match the color of the wires they are connected to. • Check that the LED driver connector is fully engaged to the LED light engine connector. • Check that the LED light engines are connected at the junction between the two luminaires.