Manual

Installation Instructions
Read these instructions completely and carefully.
ELECTRICAL CONNECTION
INFORMATION FOR
ELECTRIC DRYERS
A_ WARNING - T,,_ed.cethe_sk.f
fire, electric shock or personal injury:
• DO NOT USE AN EXTENSION CORD WITH
THIS APPLIANCE,
• THIS APPLIANCE MUST BE PROPERLY
GROUNDED.
This dryer must be electrically grounded in accordmace
with local codes mad ordinances, or ha the absence of local
codes, ha accordmace with the NATIONAL ELECTRICAL
CODE, ANSI/NFPA NO. 70 or ha Cmmda CSA C22.1
CmmdJma Electrical Code Part 1.
Electrical Requirements
• This dryer must be connected to a 208V or 240V
individual branch circuit, protected by 30-amp drcuit
breake_ or time-delay fllses.
• Power supply: 3-wire 240-volt, single-phase, 60-Hz,
Pdternating Current. (Canada-240 volt, single-phase,
60-Hz Pdternating Current.)
• Use copper conducto_ only.
• If the electric supply does not meet the above
specifications, call a licensed electrician.
NOTE: A wiring diagram is located trader the top panel.
ELECTRICAL CONNECTION
INFORMATION FOR GAS DRYERS
11
A_ WARNING - T,,reducetheriskof
fire, electric shock or personal iIIjtu3:
• DO NOT USE AN I_LTENSION CORD OR AN
ADAPTER PLUG WITH THIS APPLIANCE,
• DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD GROUNDING PRONG FROM
THE POWER CORD.
This dryer must be electrically grounded ha accordmace
with local codes mad ordhmaaces, or ha the absence of local
codes, ha accordance with the NATIONAL ELECTRICAL
CODE, ANSI/NFPA NO. 70 or ha Canada, CSA C22.1
Cmmdima Electrical Code Part 1.
Electrical Reqttirements
• This dP,'er InUSt be supplied with 120V, 60-Hz,
and connected to a propedy grounded branch
circuit, protected by a 15- or 20-amp circuit breaker
or time-delay fuse.
• If the electric supply provided does not meet the
above specifications, it is recommended that a licensed
electrician instnll an approved outlet.
Ensureproperground
existsbeforeuse
External Ground (if required)
An external ground wire (not provided), which meets local
codes, may be added by attaching it to the green ground
screw on the rear of the dryer ha the upper left corner
above the cord, mad to grounded metal cold water pipe or
other established ground.
_7' £* ...... ;I ®l
Artacbgroundwire
(obtainlocally)
NOTE: A wiring diagram is located under the top panel.