Manual

Stacking Instructions-Reversing Door Swing

Thenumbers in the illustration correspond to steps.

5. Using the blade end ofa putb' knite co',ered with

masking tape, carefllll) remoxe.... the hole I_lugs, located

in the 1)otmm of the (h-vet fl'ont panel.

Remoxe the 4 legs from the dr}er base.

Place the dryer on top of the washe_: Slide the dr}er

back into the rear brackets (7A) then drop the fl'ont

down oxer the ti'ont brackets (7B).

8. Insert the 2 long screws provided in the kit through

the holes in the dryer ti'ont panel and install into the

fl'ont mounting brackets.

9. Install the hole i)lugs removed in step 5.

10. Refer to the washer and dryer installation instructions

fin" proper installation and fimction.

11. Save the top panel and brackets in the case offlmu'e

side-by-side rise.

REVERSING THE DRYER

DOOR SWING

1. Open the d_'er doo_: Remove the 4 hinge hole phlgs or

screws fl'om the left side of door opening. Place nearby

fl)r fllture installation. NOTE: Youmay need a plastic knife

to help pull out the plugs. Be careful not to scratch the paint.

2. Remove the fimr screws that secure the door hinges to

the dryer fl'ont panel. NOTE: Remove l screw from each

of the 2 hinges first. Hold the doorfirmly before removing the

last 2 screws.

3. Rotate the door 180 ° and reinstall the door hinges to the

(h?'er tixmt panel with the 4 screws.

4. Install the 4 hinge hole i)lugs or scre_:s that were

removed in stop 1 into the open screw holes on the right

side of the door opening.

Remove4screws onefrom