Manual

Installation
Instructions
SpacemakerDryer
Models DCXH46
DSXH43
DPXH46
DH43
PSXH43
I ff youhaveanyquestions,in theU.S.,call 800.GE.CARES(800.432.2737)orvisitonrWehsiteat: ge.comIn Canada,carl 1.800.361.3400orvisitonrWehsiteat:geappliances.ca I
BEFORE YOU BEGIN
Read these instructions completely and carefully,
• IMPORTANT - S_,,ethese
instIuctions fl)r local inspector's use.
• IMPORTANT - Obsei,e ,ll
governing codes and ordinances.
• Note to Installer - Besure to leave these
instIuctions with tile Consmner.
• Note to Consumer - Keepthese instructions
tar fllture reference.
• Skill level - Installation of this appliance requires
basic mechanical and electrical skills.
• Completion time - 1-3 hours
" Proper installation is tile responsibility of tile
installer,
• Product tailure due to improper installation is not
covered under tile _,Varrantv,
IN THE COMMONWEALTH OF
MASSACHUSETTS
• This product must be installed by a licensed
plumber or gas fitter.
° When using ball-type gas shu>off valves, they
shall be the T-handle type.
° A flexible gas connector; when used, must not
exceed 3 feet.
FOR YOUR SAFETY:
./k WARNING
This dryer lnust be exhausted to tile outdools. Use
only rigid inetal or flexible metal 4" diameter ductwork
tor exhausting to tile outside. Use only rigid metal 4"
diameter ductwork inside tile di_'er cabinet,
Nexer use plastic or other combustible ductwork. See
Exhausting section.
This appliance must be properly grounded and
installed as described ill these Installation Instructions.
• Do not install or store appliance ill an area xd/ere it will
be exposed to water/weathei: See Locationof YourDryer
section.
Tile National Fuel Gas code restricts installations of
gas appfimlces ill garages. Tile}' in ust be 18" (45.7 cln )
off the ground and protected fl'om vehicles by a
barriei: See Location of YourDryorsection.
Tile dectrical service to tile dryer nmst confimn with
local codes and ordinances and the latest edition of the
National Electrical Code, ANSI/NFPA 70 or ill Canada,
CSA C22,1 Canadian Electrical Code Part 1,
Tile gas service to tile dIyer nmst confimn with local
codes and ordinances or the latest edition ot the
National Fuel Gas Code ANSI Z223.1 or ill Canada,
(]AN/C(;A B149.12. The gas dryer is designed under
ANSI Z 21.5.1 or ANSI/UI,2158-CAN/CSA C22.2
(latest editions) tar home use only. This (hTer is not
recolnlnended tor colnlnercial applications such as
I'est;ItlI';llltS oi" beatlP,' sahms.