Installation Guide

35-201578-5K (8/04) GELS
LAMPES
N’utilisez que le type de lampe spécifié sur la plaque
d’identification. Observez les recommandations et restrictions
du fabricant sur le fonctionnement de la lampe, en particulier
pour le type de ballast, la position d’utilisation, etc.
SERRAGE DE LAMPE : La lampe doit être insérée de façon
sûre avec un couple de serrage NEMA-EEI spécifié à 4,4 mkg (35 livre-
pouce), ce qui est le mieux réalisé en serrant fortement à la main pour
mettre un couple suffisant. Le serrage doit complètement appuyer et
charger le contact central de la douille avec le culot de la lampe.
ENTRETIEN
Nettoyez le globe en le lavant avec une solution détergente non
abrasive. Rincez-le à l’eau claire.
Risque de brûlure
• Laissez le bloc d’ampoule refroidir
avant d’y toucher
ATTENTION
GEH-5831A
GE Edison V Luminaire
INSTRUCTIONS
GENERAL
This luminaire is designed for use in outdoor applica-
tions and must adhere to 25°C Max ambient temperature
limitation. Install and maintain it according to the
following recommendations.
Make all electrical connections in accordance with
the National Electrical Code and any applicable
local code requirements.
Verify that supply voltage is correct by comparing it
to nameplate.
READ THOROUGHLY BEFORE INSTALLING
WARNING
Risk of electric shock
• Turn power off before servicing
– see instructions
CAUTION
Unit will fall if not installed properly
• Follow installation instructions
IF SINGLE VOLTAGE:
All single voltage ballasts are pre-wired such that user
need only connect the supply conductors.
IF MULTIVOLT: (120/208/240/277 volts)
Connect the ballast lead with the insulated terminal to
the desired voltage terminal as indicated on the ballast
terminal nameplate.
IF MULTIWATT:
Multiwatt ballasts are available in various combinations of
wattage. See wiring instructions on wiring tag inside the
luminaire.
COLONIAL
GLOBE
TRADITIONAL
GLOBE
TRADITIONAL
STANDARD
GLOBE
OPTIONAL OUTLET RECEPTACLE
When used the access door should
be re-installed with the plug cord
positioned through wire way.
Wire way for optional
outlet receptacle
LINE
GROUND
LINE OR NEUTRAL
MOUNTING
SET SCREWS
(3 FURNISHED)
TORQUE TO 18-22
FOOT-POUNDS
TERMINAL
BOARD
BASE CASTING
GLOBE
SET SCREWS
(FURNISHED)
ACCESS DOOR
Remove door to install power
connections and optional photo
control.
OPTIONAL PHOTO CONTROL
(Ordered separately)
Rotate base casting so that PE
window points away from other
light sources.
BALLAST COVER
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred
to GE Lighting Solutions.
g
GE
Lighting Solutions
g
GE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company.
© 2011 GE Lighting Solutions. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
16943533----888