Installation Guide

31-3000212 Rev. 0 3

Installation Instructions

INSTALLING LEVELING LEG

BRACKETS

• Secure both leveling leg brackets to the bottom

of the riser with the 18 short mounting screws

(9 per leveling leg bracket). After attaching the

screws, fully screw in the 4 leveling legs. Do not

tighten the lock nuts at this time.

LEVELING UNIT

• Carefully upright the washer and move it close

to its final location.

• Make sure that the washer is level by placing

a level on top. Check side to side and front to

back.

• Use and open ended wrench to adjust the legs

in and out. Tighten the lock nut against the

bottom of the pedestal.

NOTE: To minimize vibration, the locking nuts

must be tight.

INSTALLING RISER BODY

• Use an open-end wrench to remove the 4 washer

leveling legs.

• Locate the 4 plastic spacers (A) and match them

to their locations on the riser. Snap into place.

• Align top of riser body with bottom of washer and

ensure the riser hose is on the same side as the

back of the washer. Using a 5/8" socket wrench

(deep well or extension required). Install all 4 bolts

through the bottom of the riser and into the empty

leveling leg holes in the washer. DO NOT tighten.

• After all 4 bolts are in place, securely tighten.

INSTALLING THE RISER ONTO A WASHER