Installation guide

Installation Preparation
[_ LEVELING THE COMPACTOR
• The top of the compactor should be at least 1/8"
(3 ram) from the top of the cabinet opening. You can
adjust the height of the compactor by turning the
screws on the front leveling legs and rear wheels.
Front leveling legs
_els
• Place a level inside the compactor on the floor
of the cabinet.
J
/
• Use the leveling legs to adjust level front to back and
side to side.
I_ ADJUST THE RETAINING
BRACKET
Determine installation depth of the compactor
beneath the countertop,
Adjust the position of the retaining brackets so that
the screws can meet the underside of the
countertop.
Mounting clips are provided for stone or other hard
countertops that will not accept screws.
Retaining
bracket
Countertop
I_ ADJUSTING THE BASE TOEKICK
Atoekick extension is supplied. It can be used to cover
any gaps from the bottom of the compactor to the floor,
• Remove the top toekick screws as shown. Lift off top
toekick piece.
• Loosen the base toekick screws, adjust to touch the
floor and tighten the screws.
• Reinstall the top toekick piece with the original
screws.
/
Top toekick
Loosen screw
Adjustable
on each side
lower toekick