Owner's Manual

6 49-4000218 Rev 1
Getting started
USING THE DISHWASHER
Select Options
The light by the selected pad will be lit to indicate which Option has been selected.
Wash Temp
Boost/High
(on some
models)
This option increases the temperature to help clean heavily soiled dishes and will increase the
cycle time by 20 to 50 minutes. Option may be turned On or Off during the wash cycle. This
option will also improve dry performance on the Normal/Everyday cycle.
Wash
Temp
Steam/
Steam+
Sani
(on some
models)
This option has several functions. Steam is introduced at the beginning of the cycle to help with
heavily soiled and/or dried-on, baked-on soils and for sanitization of dishware along with improving dry
performance by raising the water temperature in the final rinse. The cycle length will vary depending
on the temperature of your inlet water. This option MUST be selected PRIOR to starting the cycle.
Available with Heavy/Heavy Duty, AutoSense and Normal/Everyday cycles.
NOTE: This option is monitored for sanitization requirements. If the cycle is interrupted during
or after the main wash portion or if the incoming water temperature is so low that adequate
water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the
Sanitized light will not illuminate at the end of the cycle. Utilizing this option will modify the cycle to
meet the requirements of Section 6, NSF 184 standard for soil removal and sanitization efficacy.
NOTE: Certified residential dishwashers are not intended for licensed food establishments.
Heated
Dry
(on some
models)
This option can be selected by pressing the Dry pad once to illuminate the Heated light. This
setting will greatly improve your dry performance for daily, regular or typical dishes. The heated
dry option will typically add 48 to 64 minutes to your cycle time. This option is not available with
the Rinse cycle. NOTE: The use of rinse aid can further enhance the dishwasher’s drying
performance. On models with this feature, Heated Dry was selected to rate the energy efficiency
of this dishwasher.
Heated
Dry Off
(on some
models)
Shuts off the drying option. Dishes air dry naturally and energy is saved. Opening the door at
the end of the cycle can improve drying performance. NOTE: The use of rinse aid can further
enhance the dishwasher’s drying performance.
Dry Boost
Off (on some models) - Shuts off the drying option. Dishes air dry naturally and energy is saved.
Open the dishwasher door to speed drying.
Normal (on some models) - Turns on the option for faster drying. This option may add up to 64
minutes to the cycle time. This option is not available with the Rinse cycle. On models with this
feature, Dry Boost Normal was selected to rate the energy efficiency of this dishwasher.
High (on some models) - This option can be selected by pressing the Dry Boost pad twice to
illuminate the High light. It will add additional time to your drying option, further enhancing the
dishwasher’s performance for difficult to dry items.
Bottle Jets
(on some
models)
This option increases the time that the bottle jets are on and may add up to 23 minutes to the
cycle time. Use this to wash difficult to clean, dishwasher safe baby bottles, sport bottles, tall
coffee cups, etc. See use recommendations in the Loading section.
Wash
Zones
(on some
models)
Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This
will shorten the cycle time and conserve energy. This option should be used when dishes are
placed in only one rack.
Delay
Hours
(on some
models)
Delays the start of a wash cycle up to 8 to 12 hours depending on model. Press Delay Hours, to
select the number of hours, then press Start one time and close door to begin countdown. The
cycle will start once allotted time has expired.
Lock
Control
(on some
models)
You can lock the controls after you have started a cycle to prevent cycle changes. You can also
lock the controls to prevent selections from being made. For example, children cannot accidentally
start the dishwasher by pressing pads with this option selected.
To LOCK/UNLOCK the dishwasher control, depending on the model, press and hold the Cycle
pad, or the Dry/Dry Boost and Steam pads simultaneously for 3 seconds. The Lock Controls
light will turn on to indicate the control is locked and will turn off to indicate the control is unlocked.
5