Installation guide

Dishwasher Installation
STEP 5: IF NECESSARY, REMOVE FLOOR
PROTECT (on some models)
, Disconnect leak sensor wire
(on some models).
, Remove 2 screws from front of the
Floor Protect with a 1A"driver.
, Lower front of pan and slide out from
under dishwasher.
, Set aside for use in Step 21.
Squeeze connector at top
to release snap feature
Leak Sensor
/7
Floor Protect
Figure L
STEP 8: POSITION WATER LINE
AND HOUSE WIRING
, Position water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Line Wiring
Figure O
STEP 6: INSTALL 90 ° ELBOW
Thread 90° elbow
onto the water valve.
Ensure rubber gasket Water Valve
is located between Bracket
\
valve and elbow.
, Do not overtighten
elbow. Water valve
bracket could
bend or water valve
fitting could break.
, Position the end of
the elbow to face the
rear of the dishwasher.
Figure M
Front of dishwasher
90° Elbow
Fill Hose
STEP 9: INSTALL DRAIN HOSE,
THROUGH CABINET
, Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate cabinet opening.
E
Insulation
/ Blanket
J
i House
i Wiring
(If used)
STEP 7: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp
as shown in the figure.
Figure N
NOTE: The high drain loop on the side of the tub is designed for
better wash performance. Do not remove from the side of the tub.
J
Line
/
Ensure drain hose is not
twisted or pinched
Maximum drain hose
length is 15'
Do not disconnect or remove high
drain loop from left side of dishwasher
Figure P
Tip: Prevent unnecessary service call charges for fill, drain
or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.