Installation guide

ATTN'.
GeoSpring Evaporator Leak Repair Kit
WS35X20201
f
WHEN REPLACING THE EVAPORATOR ON THE
GeoSpring WATER IT IS CRITICAL TO REPLACE
ALL COMPONENTS THAT COME WITH THE EVAPORATOR
REPAIR KIT.
Whenever there is an evaporator leak on the GeoSpring, the refrigerant oil
will drain onto the condensate drain pan/tray. This polyester oil will cause
stress cracking to occur on the condensate drain pan.
Even if there are no signs of cracking at the time of the evaporator service,
the drain pan MUST be replaced to avoid a repeat service call due to crack
developing later.
All evidence of oil MUST be removed from the tubing and surface of the
water heater before reinstalling the new evaporator.
The new barbed tee fitting MUST be used for the condensate drain since
the old fitting on the unit was likely contaminated with the refrigerant oil.
Also included in the kit is a new T3a/T3b/T4 sensor assembly. The new
sensor is more robust to moisture related failures and should be installed at
the time of the evaporator service.
WS35X20201 Kit Components
WS85X10005
WS86X10002
WJ56X10008
WSB5X20241
WS17X10014
EVAPORATOR KIT
FILTER DRYER ASM
PROCESS VALVE
CONDENSATE DRAIN PAN KIT
WS28X10073 CONDENSATE DRAIN PAN
WS22X20100 BARBED T FITTING
SENSOR ASM (T3a/T3b/T4)

Summary of content (2 pages)