Manual

About the control and. GEAliances.com
GeoSpring
O
O
@
-Fl: Fotq
m HEAT PUMP
[ J
u HYBRID
u HIGH DEMAND/BOOST
u ELECTRIC/STANDARDFnl,'_
N VACATION ode j
0 )
@
(on some models)
°
Hold for Hold to Override Hold to
°F/°C PS-P(_werSaver Reset
D
@
Control Features
1. Display
2. Operating Modes
(Seepage 8 for description)
3. Vacation
(Seepage 8 for description)
4. Mode Selector
Use this button to alternate between available modes.
5. Arrow Pads
Use these buttons to adjust the temperature setting.
6. Enter Key
7. Filter Reset
The filter is dirty and requires cleaning when the Red light is
illuminated. Filter is located on top of the water heater. Press
button and hold for 5 seconds to reset filter alarm.
J
8. Power Saver Override
For use with ACM module. Pressand hold to bring unit out of
Power Saver mode. Once pressed and Power Saver mode is
cancelled, unit will remain out of Power Saverfor the next 18
hours.
9. Appliance Communication Module Port
For use with optional ACMmodule (see page 10for details).
10. Anode Reset (on some models)
When the red light is illuminated, the system has indicated that
the anode rod is approaching end of life and it is recommended
to replace it. Pressbutton once to silence alarm. Pressand
hold for 10 seconds to reset the anode alarm after replacing.
Call GEservice to replace the anode rod. Failure to replace the
anode rod will void warranty coverage and may result in a tank
leak. (Seepage 14 for instructions to change the anode rod.)
GEService:888.4GE.HEWH(888.443.4394).
11. Communication Indicator
The LEDis illuminated when the GeoSpring is enabled for
communication through the ACM module. See page 10 for
description.