- General Electric Computer Accessories User Manual

iv
•
••
•
Contents Innovation Series Medium Voltage GP Type – G Drives GEH-6385
Drive Commissioning: Current Limits.......................................................................4-27
Drive Commissioning: Power Dip Ride-Through.......................................................4-27
Drive Commissioning: Parameter Calculation............................................................4-27
Drive Commissioning: Simulator Mode.....................................................................4-27
Drive Commissioning: Hardware Fault Strings in Simulator Mode ............................4-27
Drive Commissioning: Simulator Mechanical Configuration......................................4-27
Drive Commissioning: Exit Reminder .......................................................................4-28
Drive Commissioning: Conclusion ............................................................................4-28
Line Transfer Tuneup ......................................................................................................4-28
Line Transfer Tuneup: Overview...............................................................................4-28
Line Transfer Tuneup: Motor Transfer Data ..............................................................4-28
Line Transfer Tuneup: Motor Capture Data ...............................................................4-29
Line Transfer Tuneup: Operation ..............................................................................4-29
Motor Control Tuneup.....................................................................................................4-31
Motor Control Tuneup: Equivalent Circuit ................................................................4-31
Motor Control Tuneup: Measurements ......................................................................4-32
Motor Control Tuneup: Operation .............................................................................4-32
Panel Meter Setup............................................................................................................4-32
Per Unit Setup .................................................................................................................4-32
Line Protection Setup.......................................................................................................4-33
Line Protection: Introduction.....................................................................................4-33
Line Protection: Default Settings...............................................................................4-33
Line Protection: Overvoltage.....................................................................................4-33
Line Protection: Undervoltage...................................................................................4-33
Line Protection: Overfrequency.................................................................................4-34
Line Protection: Underfrequency...............................................................................4-34
Line Protection: Conclusion ......................................................................................4-34
Pulse Test ........................................................................................................................4-34
Pulse Test: Introduction ............................................................................................4-34
Pulse Test: Analog Output Configuration ..................................................................4-35
Pulse Test: Bridge State Configuration ......................................................................4-35
Pulse Test: Timer Configuration................................................................................4-37
Pulse Test: Operation ................................................................................................4-37
Remaining Parameter Setup .............................................................................................4-37
Simulator Setup ...............................................................................................................4-38
Simulator Setup: Introduction....................................................................................4-38
Simulator Setup: Simulator Mode..............................................................................4-38
Simulator Setup: Hardware Fault String Override......................................................4-38
Simulator Setup: Simulator Mechanical Configuration...............................................4-38
Simulator Setup: Conclusion .....................................................................................4-38
Speed Regulator Tuneup..................................................................................................4-39
Speed Regulator Tuneup: Model ...............................................................................4-39
Speed Regulator Tuneup: System Inertia ...................................................................4-39
Speed Regulator Tuneup: Inertia Measurement Command .........................................4-39
Speed Regulator Tuneup: Speed Regulator Mode ......................................................4-40
Speed Regulator Tuneup: Manual Regulator Tuneup .................................................4-40
Speed Regulator Tuneup: 1st Order Response............................................................4-40
Speed Regulator Tuneup: 2nd Order Response ..........................................................4-40
Speed Regulator Tuneup: 2nd Order Response with Stiffness Filter ...........................4-41
Speed Regulator Tuneup: Calculate Speed Regulator Gains Command ......................4-41