- General Electric Computer Accessories User Manual

4-2 •
••
• Chapter 4 Wizards Innovation Series Medium Voltage GP Type - G Drives GEH-6385
Drive Commissioning: Starting and Stopping the Drive................................4-19
Drive Commissioning: Manual Reference....................................................4-19
Drive Commissioning: Maximum Speed References....................................4-20
Drive Commissioning: Jog Speed Setpoints.................................................4-20
Drive Commissioning: Reference Ramp Bypass...........................................4-20
Drive Commissioning: Reference Ramp Mode.............................................4-20
Drive Commissioning: Reference Ramp Speed Independent Rates...............4-21
Drive Commissioning: Reference Ramp Speed Independent Rate Set
Selection .....................................................................................................4-21
Drive Commissioning: Reference Ramp Programmed Acceleration Rates ....4-22
Drive Commissioning: Reference Ramp Programmed Acceleration Speeds ..4-22
Drive Commissioning: Reference Ramp Programmed Deceleration Rates ....4-22
Drive Commissioning: Reference Ramp Programmed Deceleration Speeds ..4-23
Drive Commissioning: DDI Increment and Decrement Rates (Local Mode)..4-23
Drive Commissioning: Speed/Torque Regulator Configuration ....................4-23
Drive Commissioning: Speed/Torque Regulator Modes ...............................4-23
Drive Commissioning: Torque Regulator Reference.....................................4-24
and Output ..................................................................................................4-24
Drive Commissioning: Torque with Speed Override Reference and Output ..4-24
Drive Commissioning: Torque with Speed Override Speed Error .................4-24
Drive Commissioning: Torque with Speed Override Stopping Behavior.......4-25
Drive Commissioning: Torque and Current Limits.......................................4-25
Drive Commissioning: Torque and Current Limits Uniform.........................4-25
Drive Commissioning: Failed Calculation....................................................4-26
Drive Commissioning: Torque and Current Limit Selection .........................4-26
Drive Commissioning: Normal Torque and Current Limits ..........................4-26
Drive Commissioning: Alternate Torque and Current Limits........................4-26
Drive Commissioning: Motoring Torque Limits...........................................4-26
Drive Commissioning: Generating Torque Limits........................................4-26
Drive Commissioning: Current Limits .........................................................4-27
Drive Commissioning: Power Dip Ride-Through.........................................4-27
Drive Commissioning: Parameter Calculation ..............................................4-27
Drive Commissioning: Simulator Mode.......................................................4-27
Drive Commissioning: Hardware Fault Strings in Simulator Mode...............4-27
Drive Commissioning: Simulator Mechanical Configuration ........................4-27
Drive Commissioning: Exit Reminder .........................................................4-28
Drive Commissioning: Conclusion ..............................................................4-28
Line Transfer Tuneup.........................................................................................4-28
Line Transfer Tuneup: Overview.................................................................4-28
Line Transfer Tuneup: Motor Transfer Data.................................................4-28
Line Transfer Tuneup: Motor Capture Data .................................................4-29
Line Transfer Tuneup: Operation.................................................................4-29
Motor Control Tuneup .......................................................................................4-31
Motor Control Tuneup: Equivalent Circuit...................................................4-31
Motor Control Tuneup: Measurements.........................................................4-32
Motor Control Tuneup: Operation................................................................4-32
Panel Meter Setup ..............................................................................................4-32
Per Unit Setup....................................................................................................4-32
Line Protection Setup .........................................................................................4-33
Line Protection: Introduction .......................................................................4-33
Line Protection: Default Settings .................................................................4-33
Line Protection: Overvoltage.......................................................................4-33
Line Protection: Undervoltage .....................................................................4-33
Line Protection: Overfrequency ...................................................................4-34
Line Protection: Underfrequency .................................................................4-34
Line Protection: Conclusion ........................................................................4-34