- General Electric Computer Accessories User Manual

8
•
••
•
Index Innovation Series Meduim Voltage GP – Type G Drives GEH-6385
Gnd current, coarse, 3-54
Gnd flt trip, 3-66, 3-67
Gnd flt warning, 3-66, 3-67
GP Constant 1, 3-10
GP Constant 2, 3-10
GP Constant 3, 3-10
GP filter 1 output, 3-11
GP filter 2 output, 3-11
GP filter 3 output, 3-11
GP filter 4 output, 3-11
GP lan fbk bit 1, 3-42, 3-43
GP lan fbk bit 2, 3-42, 3-43
GP lan fbk bit 3, 3-42, 3-43
GP lan fbk bit 4, 3-42, 3-43
GP lan fbk bit 5, 3-42, 3-43
GP lan fbk bit 6, 3-42, 3-43
GP lan fbk bit 7, 3-42, 3-43
GP lan fbk bit 8, 3-42, 3-43
GP lan fbk reg 1, 3-41, 5-7
GP lan fbk reg 2, 3-41, 5-7
GP lan fbk reg 3, 3-41, 5-7
GP lan fbk reg 4, 3-41, 5-7
GP lan ref 1, 3-39, 5-7
GP lan ref 2, 3-39, 5-7
GP lan ref 3, 3-39, 5-7
GP lan ref 4, 3-39, 5-7
GP lan req bit 1, 3-40, 3-52
GP lan req bit 2, 3-40
GP lan req bit 3, 3-40
GP lan req bit 4, 3-40
GP lan req bit 5, 3-40
GP lan req bit 6, 3-40
GP lan req bit 7, 3-40
GP lan req bit 8, 3-40, 3-52
Heartbeat fbk, lan, 3-37, 3-42, 5-8
Heartbeat ref, lan, 2-37, 3-36, 3-37, 3-40, 5-8
Heat sink A temp, 3-56, 3-57
Heat sink B temp, 3-56, 3-57
Heat sink C temp, 3-56, 3-57
I/O test mode, 3-30
Ia^2 filtered, 2-4, 2-6, 3-61, 3-62
Ib^2 filtered, 2-4, 2-6, 3-61, 3-62
Ic^2 filtered, 2-4, 2-6, 3-61, 3-62
In cur or trq limit, 3-42
Inertia, 3-18, 3-108, 3-109, 3-111, 4-40
Ix command neg limit, 3-101
Ix command pos limit, 3-101
Jog active, 3-42, 3-83, 5-8
Jog request, 3-40, 3-79, 3-82, 3-83, 3-90, 3-91, 3-92,
3-93, 4-18, 4-19, 5-8
Jog request, lan, 3-40, 3-82, 5-8
LAN commands OK, 3-37, 3-79, 3-81, 3-82, 3-83, 5-
4
LAN connection ok, 2-37, 3-37
Lan diag fbk bit 1, 3-42
Line monitor frq, 3-70, 3-71, 3-72
Line monitor volt, 3-70, 3-71, 3-73
Line xfer enabled, 3-46
Local dec command, 3-90, 3-91
Local fault string, 3-33, 3-42, 3-55, 3-77, 4-27, 5-8
Local fault test, 3-31
Local inc command, 3-90, 3-91
Local mode active, 3-82, 3-90, 3-91, 3-93, 3-97, 3-98,
4-19
Local rev request, 3-97, 3-98
LP fuse stat, 3-66
MA close command, 3-87
MA cont enable req, 3-86, 3-87
MA cont enable stat, 3-42, 3-86, 3-87
MA cont test mode, 3-31
MA contactor closed, 3-33, 3-87, 5-9
Min speed output, 3-89
Motor current, 3-41, 4-10, 5-7
Motor current, lan, 3-41, 5-7
Motor current, unfil, 3-41
Motor flux, 3-23
Motor power, 3-41, 5-7
Motor power, lan, 3-41, 5-7
Motor speed, 3-18, 3-105, 3-106
Motor torque, lan, 3-41, 5-7
Motor voltage, 3-41, 5-7
Motor voltage, lan, 3-41, 5-7
Motoring torque lim, 3-101, 3-102, 4-26
MOV fuse OK status, 3-66
No faults active, 3-33, 3-42, 3-75, 3-85
No trip fault, 3-33, 3-42, 3-75
Normal, 2-19
Number of channels, 3-5
Output freq, unfil, 3-51, 3-105
Output frequency, 3-105, 3-106
Output volts, A-B, 3-58, 3-59, 4-35
Output volts, B-C, 3-58, 3-59, 4-35
Phase A current, 3-54, 3-60, 3-61, 4-35
Phase B current, 3-54, 3-60, 3-61, 4-35
Phase C current, 3-54, 3-60, 3-61, 4-35
Phase imbalance avg, 3-68, 3-69
Phase imbalance int, 3-68, 3-69
Phase imbalance ref, 3-68, 3-69
Phase imbalance sqr, 3-68, 3-69
Phs A current offset, 2-20, 3-60, 3-61
Phs B current offset, 2-20, 3-60, 3-61
Phs C current offset, 2-20, 3-60, 3-61
Phs imbalance limit, 3-68, 3-69
Phs imbalance time, 3-68, 3-69
PLL error, 3-68, 3-69, 3-72
PLL frequency, 2-33, 3-72
PLL integral gain, 3-72
PLL max frequency, 3-72
PLL min frequency, 3-72
PLL prop gain, 3-72
PLL proven, 3-68, 3-69, 3-73
Pos cntr mark, 3-13