- General Electric Dishwasher User Manual

Installation Instructions

• Align the toekick with the bottom edge and make

sure it is against the floor.

• Insert and tighten the two toekick attachment

screws. The toekick should stay in contact with the

floor.

TIP: Make sure toekick is against floor to minimize

noise.

FigureBB

STEP 19 LITERATURE

• Be sure to leave complete literature package and

installation instructions with the consumer.

STEP 18 REPLACE TOEKICK

• Place toekick against the legs of the dishwasher.

STEP 17

DISHWASHER WET TEST

¨ Turn on power supply (or plug power cord into

outlet, if equipped).

¨ Latch door.

¨ Push “Normal Wash” button.

¨ Push start/reset pad once.

¨ Check to be sure that water enters the dishwasher.

If water does not enter the dishwasher, check to be

sure that water and power is turned on.

¨ Check for leaks under the dishwasher. If leak is

found, turn power supply off, then tighten connec-

tions. Restore power after leak is corrected.

¨ Check for leaks around the door. A leak around the

door could be caused by door rubbing or hitting

against adjacent cabinetry. Reposition the dish-

washer if necessary. See Step 12.

¨ The dishwasher will drain about 5 minutes after the

first fill. Check drain lines. If leaks are found, turn

power off, correct as necessary. See Step 14.

¨ Open dishwasher door and make sure most of the

water has drained. If not, check that disposer plug

has been removed and/or air gap is not plugged.

See Step 14.

¨ Let dishwasher run through another fill and drain

cycle. Check again for leaks and correct as required.

¨ At the end of the second drain, push the start/reset

pad once. Wait for dishwasher to pump out and

then unlatch the door.

Attachment Screws

oekick