User's Manual
GEAppliances.com
27
It’s a good idea to wipe the control panel after 
each use of the oven. Use a damp cloth to 
clean or rinse. For cleaning, use mild soap and 
water or a 50/50 solution of vinegar and water. 
For rinsing, use clean water. Polish dry with a 
soft cloth.
Do not use abrasive cleansers, strong liquid 
cleaners, plastic scouring pads or oven cleaners 
on the control panel³they will damage the 
finish.
The control knobs may be removed for easier 
cleaning.
Make sure the knobs are in the OFF positions 
and pull them straight off the stems for 
cleaning.
The knobs can be cleaned in a dishwasher or 
they may also be washed with soap and water. 
Make sure the insides of the knobs are dry 
before replacing.
Replace the knobs in the OFF position to ensure 
proper placement.
Pull the knob straight off the stem.
Control Panel and Knobs
Warming Drawer Rack
(on some models)
Clean the rack with detergent and water. After 
cleaning, rinse the rack with clean water and 
dry with a clean cloth.
Removable Warming Drawer (on some models)
NOTE: For models with an electric 
warming drawer, before performing 
any adjustments, cleaning or service, 
disconnect the range electrical power 
supply at the household distribution panel 
by removing the fuse or switching off the 
circuit breaker. Make sure the warming 
drawer heating element is cool.
Most cleaning can be done with the drawer in 
place. However, the drawer may be removed if 
further cleaning is needed. Use soap and warm 
water to thoroughly clean.
To remove the warming drawer:
 Pull the drawer straight out until it stops.
 Press the left rail release up and press the 
right rail release down, while pulling the 
drawer forward and free.
To replace the warming drawer:
 Place the left drawer rail around the inner 
left rail guide and slide it in slightly to hook it.
 Place the right drawer rail around the 
inner right rail guide and slide it in slightly 
to hook it.
 Slide the drawer all the way in.
On glass cooktop models, the oven is vented 
through an opening at the rear of the cooktop.
On coil cooktop models, the oven is vented 
through an opening under the right rear 
surface unit. 
Never cover the opening with aluminum foil or 
any other material. 
Oven Vent










