User's Manual

Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions
32
Installation of the range.
Read these instructions completely and carefully.
To Make Electrical Connection (if range has electric ignition)
CAUTION—FOR PERSONAL SAFETY: DO NOT
USE AN EXTENSION CORD WITH THIS
APPLIANCE.
■ This appliance must be supplied with the
proper voltage and frequency, and connected
to an individual, properly grounded and
polarized branch circuit, protected by a circuit
breaker or time-delay fuse, as noted on the
rating plate.
■ Wiring must conform to National Electrical
Codes or the prevailing local code for a range
of this kilowatt rating. (See the rating plate
under the cooktop for this information.)
■ If the electric supply provided does not meet
the above specifications, call a licensed
electrician.
Light and Adjust Surface Burner Pilots (if range has standing pilots)
Purge all air from the supply system by
setting one of the surface burner control
knobs to HI for 15 seconds.
Turn the surface burner control knob to
OFF and light the pilot burners with a match.
(See the Lighting Instructions for Standing Pilot
Models in the Using the surface burners
section in this Owner's Manual.) Adjust pilot
flames using the adjusting screw, accessed
through a hole in the front right side of the
burner box under the cooktop, so that each
flame is approximately 1/4-inch in height.
To light any top burner, push and turn
burner knob to the LITE position.
When burner has ignited, rotate knob to
desired flame setting.
WARNING!
Electrical Grounding Instructions
This appliance is equipped with a three prong
grounding plug for your protection against shock
hazard and should be plugged directly into a
properly grounded receptacle. Do not cut or
remove the grounding prong from this plug.
INSURE PROPER GROUND EXISTS BEFORE USE.
To adjust the pilots, lift and prop open the cooktop.
Then use a small flat-bladed screwdriver to turn the
adjusting screw (accessed through a hole in the
front right side of the burner box).
Pilot
adjustment