Installation Guide

19
Installation Instructions
Attach the microwave oven to the top cabinet.
Insert 2 self-aligning screws through outer top
cabinet holes. Turn two full turns on each screw.
3
MOUNT THE MICROWAVE OVEN
B5.
CAUTION
FOR EASIER INSTALLATION AND
PERSONAL SAFETY, WE RECOMMEND THAT TWO
PEOPLE INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the
cord.
NOTE: We recommend using filler blocks if the cabinet
front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from
overtightening screws.
Insert a self-aligning screw through top center cabinet
hole. Temporarily secure the oven by turning the
screw at least two full turns after the threads have
engaged. (It will be completely tightened later.) Be
sure to keep power cord tight. Be careful not to pinch
the cord, especially when mounting flush to bottom of
cabinet.
Lift microwave, tilt it forward, and hook slots at back
bottom edge onto four lower tabs of mounting plate.
NOTE: When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1–3. Do not pinch cord
or lift oven by pulling cord.
5
Cabinet Front
Cabinet Bottom Shelf
7
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Install grease filter. See the Owner’s Manual
packed with the microwave.
Filler Block
Microwave Oven Top
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screws
Self-Aligning Screw
6
4
1
2
Rotate front of oven up against cabinet bottom.
Power Cord