Installation Guide

ALIGNING THE WALL PLATE

Draw a vertical line on the wall at the center of the 30”

wide space.

Use the mounting plate as the template for the rear

wall. Place the mounting plate on the wall, making

sure that the tabs are touching the bottom of the

cabinet or the level line drawn in Step C for cabinets

with front overhang. Line up the notch and center line

on the mounting plate to the center line on the wall.

While holding the mounting plate with one hand,

draw circles on the wall at holes A, B, C and D (see

illustration above/actual plate marked with arrows) . Four

holes must be used for mounting.

NOTE: Holes C and D are inside area E. If neither

C nor D is in a stud, find a stud somewhere in area E and

draw a fifth circle to line up with the stud. It is important

to use at least one wood screw mounted

firmly in a stud to support the weight of the oven.

Set the mounting plate aside.

Drill holes on the circles. If there is a stud, drill a

/16” hole

for wood screws. For holes that don’t line up with a stud,

drill a

/8” hole for toggle bolts.

NOTE: DO NOT MOUNT THE PLATE

AT THIS TIME.

Draw a

Vertical Line

on Wall from

Center of Top

Cabinet

Area E

Hole A

Hole B

Hole D

Installation Instructions

CAUTION: Wear

gloves to avoid cutting

fingers on sharp edges.

Hole C

NOTE: Appearance and

shape of the mounting

plate may vary from your

model.