Owner Manual
Table Of Contents
49-4000214 Rev 0 7
USING THE DISHWASHER
Getting started
Select Cycle
Press the furthest pad on the left for the desired wash cycle. On some models, the light next to the furthest 
pad on the left will be lit to indicate which wash cycle has been selected. On other models, pressing the 
furthest pad on the left will show various cycles in the display window. Press the pad until the desired cycle is 
shown.
NOTE: Actual cycle times vary based on soil level, water temperature, and options selected.
The cycle may be selected with the door in the open position. The cycle will not start until the Start pad is 
pushed and the door is closed within 4 seconds.
AutoSense/
Auto  
(on some 
models)
This cycle automatically senses the soil level and adjusts the wash cycle accordingly. *Time 
range:1hour50minutes-2hours10minutes.
Heavy/
Pots
This cycle is meant for heavily soiled dishes, cookware, pots, or pans with dried-on or baked-on 
soils.Everydaydishesaresafetobeusedinthiscycle.*Time:2hours31minutes.
Normal This cycle is meant for daily, regular, or typical use to completely wash a full load of normally 
soileddishesandisdesignedtoconservebothwaterandenergy.*Timerange:1hour15
minutes - 1 hour 50 minutes. NOTE: Normal was used to rate the energy efficiency of this 
dishwasher.
Light/
China
This cycle is for light to medium soiled dishes. It is safe for china and crystal with no options 
selected.*Time:55minutes.
Rinse 
(on some 
models)
For rinsing partial loads that will be washed later. Do not use detergent. Detergent is not 
dispensedduringtherinsecycle.*Time:16minutes.
1-Hour 
Wash
This cycle will quickly wash lightly soiled dishes. *Time:60minutes.For better drying, select Dry 
Boost. This will raise the final rinse temperature and extend the dry time. Dry Boost will add 49 
to 90 minutes to the cycle time. When the Clean light comes on, open the door, pull the racks 
out, and the dishes will “flash” dry in approximately five minutes.
*Washing time only. Does not include drying time, Auto Hot Start, or options. NOTE: If the incoming water 
temperature is too low, the Auto Hot Start feature may add up to 25 minutes of additional time.
4










