Spec Sheet

ManualsBrandsGE ManualsWasher & Dryer SetGE GEWADREWD14831

Specification Created 8/18

For answers to your Monogram, GE Café

™

Series, GE Profile

™

Series or

GE Appliances product questions, visit our website at geappliances.com

or call GE Answer Center

Service, 800.626.2000.

GFT14ESSMWW

4.1 Cu.Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

CIRCUIT REQUIREMENTS: An individual,

properly grounded branch circuit, protected by

a 30-amp circuit breaker or a time-delay fuse, is

required.

NOTE: Dryer wall outlet must be located within

36" of service cord entry and accessible when dryer

is mounted in position.

INSTALLATION INFORMATION: For complete

information, see installation instructions packed

with your dryer.

ELECTRIC DRYER RATING

240V 2800W, 12A, 60Hz

23 7/16" 25 1/4"

33 1/4"

42 13/16"

33 1/4"

Summary of content (5 pages)

PAGE 1
GFT14ESSMWW GE® 4.1 Cu.Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES) ELECTRIC DRYER RATING 240V 2800W, 12A, 60Hz CIRCUIT REQUIREMENTS: An individual, properly grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay fuse, is required. NOTE: Dryer wall outlet must be located within 36" of service cord entry and accessible when dryer is mounted in position.
PAGE 2
GFT14ESSMWW GE® 4.1 Cu.Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer SPECIAL INSTALLATION REQUIREMENTS: STACKED DIMENSIONS (IN INCHES) ALCOVE OR CLOSET INSTALLATION: Stacking Kit - GFA24KITL (not included) 23 7/16" If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
PAGE 3
GFT14ESSMWW GE® 4.1 Cu.Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer INSTALLATION INFORMATION PLATFORM REQUIREMENTS TO MEET THE GUIDELINES FOR THE AMERICANS WITH DISABILITIES ACT (ADA) FABRICATE A WOODEN PLATFORM FOLLOWING THESE REQUIRED INSTRUCTIONS FOR ADA COMPLIANCE: 1. The platform must raise the appliance at least 3", but not more than 7". 2. A hardwood fascia board that is 1" thick is required on any open side of the platform.
PAGE 4
GFT14ESSMWW GE® 4.1 Cu.Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer DRAINING WATER OUT OF THE DRYER - Two options are available to drain the water out. - Pump to a removeable water tank in the dryer. - Drain directly out of unit into a standpipe or washstand through the included drain hose. - The dryer drain hose and wire ties are included. - You must have a standpipe available to drain into.
PAGE 5
GFT14ESSMWW GE® 4.1 Cu.Ft.