Spec Sheet

GFW148SSMWW
GE
®
2.4 DOE Cu. Ft. Frontload Washer with Steam
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Specification Revised 11/18
STACKED DIMENSIONS (IN INCHES)
66 1/2"
23 7/16" 25 5/8"
33 1/4"
20 1/2"
3 3/8"
STACKED INSTALLATION:
- Kit for stacking dryer over washer is not included with the washer.
Order part no. GFA24KITL
ALCOVE OR CLOSET INSTALLATION:
- If your dryer is approved for installation in an alcove or closet, it will be
stated on a label on the dryer back.
- The dryer MUST be exhausted to the outside with the exception of the
condensing dryer.
- Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 1" left and right sides, 1" top, 3" front and rear.
- Minimum clearances between washer cabinet and adjacent walls or other
surfaces are: 1" left and right sides, 1" top, 1" front and rear..
- Closet doors must be louvered or otherwise ventilated and must contain a
minimum of 60 sq. in. of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of
open area equally distributed.
- No other fuel-burning appliance shall be installed in the same closet with a
gas dryer.
BATHROOM OR BEDROOM INSTALLATION:
- The dryer MUST be exhausted to the outdoors with the exception of the
condensing dryer.
- The installation must conform with the local codes, or in the absence of
local codes, with the National Electric Code and National Fuel Gas Code,
ANSI Z223 for gas dryers.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INSTALLATIONS:
- Minimum clearances to combustible surfaces 0" both sides, 3" rear.
FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.