Spec Sheet

GFW148SSMWW
GE
®
2.4 DOE Cu. Ft. Frontload Washer with Steam
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Specification Revised 11/18
PLATFORM REQUIREMENTS TO MEET THE GUIDELINES
FOR THE AMERICANS WITH DISABILITIES ACT (ADA)
FABRICATE A WOODEN PLATFORM FOLLOWING THESE
REQUIRED INSTRUCTIONS
FOR ADA COMPLIANCE:
1. The platform must raise the appliance at least 3", but not more than 7".
2. A hardwood fascia board that is 1" thick is required on any open side
of the platform. The fascia board must have a lip height of 1" above the
top to allow the consumer to open the front clean-out panel. Each fascia
board must be attached with minimum of six 1/4" - 20 x 4" bolts with
fender washers and locknuts on the backside.
3. The suggested maximum distance between lateral supports is 10".
4. Plywood top must be 3/4" thick.
5. The platform length can be dimensioned to fit one or multiple front
loading compact laundry units.
6. The platform must be firmly secured, at least at two points, to an
adjacent wall.
7. Place the front loading compact laundry unit(s) on the completed
platform.
8. The front of any front loading compact laundry unit must be less than 10"
from the front of the platform including the fascia board.
9. Follow the Installation Instructions shipped with your washer and/or
dryer to complete the installation.
INSTALLATION INFORMATION
QUESTIONS? CALL 800.GE.CARES (800.432.2737)
OR VISIT OUR WEB SITE AT: GEAPPLIANCES.COM
Front loading compact washer shown mounted on the wooden
platform which is secured to adjacent wall