Quick specs

GFD45ESSK/ESPK

GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer

For answers to your Monogram, GE Café

™

Series, GE Profile

™

Series or

GE Appliances product questions, visit our website at geappliances.com

or call GE Answer Center

Service, 800.626.2000.

Specification Revised 6/16

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

EXHAUST OPTIONS: 4-way via rear, right,

left and bottom.

CIRCUIT REQUIREMENTS: An individual,

properly grounded branch circuit, protected by

a 30-amp circuit breaker or a time-delay fuse,

is required.

NOTE: Dryer wall outlet must be located within 36"

of service cord entry and accessible when dryer is

mounted in position.

INSTALLATION INFORMATION: For complete

information, see installation instructions packed

with your dryer.

39-3/8

4-3/8

5-3/8

ELECTRIC DRYER RATING

120V/240V 5600W, 24A, 60Hz

120V/208V 4400W, 22A, 60Hz

Listed by

Underwriters

Laboratories

PAGE 1
GFD45ESSK/ESPK GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES) ELECTRIC DRYER RATING 120V/240V 5600W, 24A, 60Hz 120V/208V 4400W, 22A, 60Hz 27 33 EXHAUST OPTIONS: 4-way via rear, right, left and bottom. CIRCUIT REQUIREMENTS: An individual, properly grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay fuse, is required.
PAGE 2
GFD45ESSK/ESPK GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer SPECIAL INSTALLATION REQUIREMENTS: STACKED INSTALLATION: Brackets for stacking dryer over washer are not included with the dryer. Order part no. GEFLSTACK or part no. WE25X10018. ALCOVE OR CLOSET INSTALLATION: If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back. STACKED DIMENSIONS (IN INCHES) 50-5/8 24-7/8 3-1/2 3 The dryer MUST be exhausted to the outside.
PAGE 3
GFD45ESSK/ESPK GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer DRYER EXHAUSTING INFORMATION –METAL DUCT ONLY For complete information, see installation instructions packed with your dryer. DUCTING MATERIALS: For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible metal (semi-rigid) ducting can be used (Kit WX08X10077).
PAGE 4
GFD45ESSK/ESPK GE Appliances 7.5 Cu. Ft.