Full Product Manual

Side opening
29
Fixing hole
A
15
3
ø4”
Installation Instructions
SIDE VENTING:
Dryer Exhaust to right of cabinet for Electric
models only.
Dryer Exhaust to left of cabinet for Gas and
Electric models.
Detach and remove the right (electric models only)
or left side knockout as desired. Remove the screw
inside the dryer exhaust duct and save. Pull the
duct out of the dryer.
Cut the duct as shown and keep portion A.
ADDING A NEW DUCT
Reconnect the cut portion (A) of the duct to the
blower housing. Make sure that the shortened duct
is aligned with the tab in the base. Use the screw
saved previously to secure the duct in place through
the tab on the appliance base.
ADDING ELBOW AND DUCT FOR EXHAUST TO
SIDE OF CABINET
• Insert the 4” elbow through the rear opening and
connect the elbow to the dryer internal duct.
Remove
screw
and save
Remove desired
knockout (one only)
Right
(electric
models
only)
Left
TAB LOCATION
Through the rear opening, locate the tab in the
middle of the appliance base. Lift the tab to about
45°,
using a flat-blade screwdriver.
Bend tab
up 45°
Not for gas
- Fire Hazard
WARNING
Disconnect dryer from electrical supply.
Wear gloves and arm guards.
Close the back opening with cover plate (Kit
WE49X22606).
Failure to do so may result in fire, electrical shock
or lacerations.
Portion “A”
Right (electric
models only)
or left side
exhaust
Fixing hole
Left
Right
Internal duct
Rear
opening
Exhaust can be
added to right
(electric models
only) or left side
Left
Right
• Insert the 4” duct through the side opening and
connect it to the elbow.
Do not pull or damage the electrical wires and
do not remove the vinyl cover from the electrical
components inside the dryer when inserting the
duct. A slight interference may occur between the
exhaust and the wire components.