Full Product Manual

Installation Instructions
39
STACKING THE WASHER AND
DRYER (if desired) (cont.)
INSTALLATION PREPARATION
Remove the packaging.
Flatten the product carton to use as a pad to lay the
dryer down on its side. Continue using the carton to
protect the finished floor in front of the installation
location.
STACKING KIT GEFLSTACK CONTENTS
(OPTIONAL ACCESSORY)
 Left hand bracket

Right hand bracket

4 rubber pads

4 #12 x 1” screws

4 #8 x 1/2” screws
TOOLS YOU WILL NEED
 Phillips screwdriver

Open-ended wrench

Pliers

Gloves

Level
INSTALLING THE STACK BRACKET
KIT
REMOVE THE DRYER LEVELING LEGS
A. Carefully lay the dryer on its side. Use the
packing material so you don’t scratch the finish
on the dryer.
1
B. Use an open-end wrench or pliers to remove the
dryer leveling legs.
Back out and
remove all 4
leveling legs
INSTALL RUBBER PADS TO DRYER
BASE
Locate the 4 rubber pads in the parts package.
Remove the adhesive backing and firmly place
over each bracket where you removed the
leveling legs.
2
Place pads over
all four leveling
leg brackets
NOTE: Models with Built-In Pedestal™ cannot be
stacked.