Owner's Manual / Installation Instructions
49-3000206 Rev 1 31
Installation Instructions
REVERSING THE DOOR SWING (Optional)
REMOVE, ROTATE AND REPLACE
THE HANDLE AND HINGE INTO
THE OPPOSITE SIDES
• Lift the handle and the hinge out of the door pockets.
NOTE: Make sure the latch remains seated inside the
handle. If it moves or falls out, seat it back into place.
• Rotate the handle and hinge, and replace them
back into the pockets on the opposite sides.
3
REPLACE THE INNER DOOR
• Replace the inner door frame into the outer door.
•
Replace the 14 screws into the inner door, using a
Phillips-head screwdriver, securing it to the outer door.
NOTE: Make sure the gasket is properly seated on
the inner door frame when replaced.
4
REPLACE THE STRIKE PLATE
AND DOOR ASSEMBLY
• On the opposite side from where removed, replace
the strike plate with its two screws using a T-25 torx
driver.
• Lift the door assembly into place and secure it onto
the dryer face with its two screws using a 1/4” nut driver.
• Close the dryer door.
NOTE: Make sure the door opens and closes
correctly. If not, repeat all steps making sure the
gasket, all parts, and screws are securely seated.
5
Hold the Door and
Replace Hinge Screws
into the Dryer
Replace Strike
Plate and Screws